BLADEZ PB-SM806 Guia de Resolução de Problemas descarregar pdf (Página 15)

Page 15

Tire wear will differ based on rider weight, riding conditions and care. Replacement tires

can be obtained at your local Bladez dealer, through motorcycle shops, or from the

Bladez website at www.ebladez.com. The Bladez EX 350 uses a standard Kenda 7.5"

(2.00 x 50) pneumatic tire.

Tire Pressure

The tire must be inflated to a maximum of 50 P.S.I.. It is also recommended to use a

tube additive like Slime purchasable from any motorcycle shop, to avoid inconvenient

punctures.

CHAIN CARE

Proper chain care will increase the life and improve performance of your Power Board.

Always keep the chain lubricated and tightened to proper tension.

Lubrication

Always keep the chains lubricated with a good chain spray or grease (not chain wax). If

the chain is allowed to run dry for a prolonged period of time it will fail, and the life of the

chain is severely shortened.

Chain Adjustment

The chain on the EX 350 should be adjusted from time to time. The chain should be

tight enough not to skip, but have a little bit of play. If you feel your chain skipping or

make a popping noise, adjust the tension immediately.

For regular adjustments:

1. Using a 16mm wrench, loosen the

axel bolts on each side of the rear

wheel (Fig. 9).

2. While the axel bolts are loose, using

a 10mm wrench loosen the tension

bolts behind the rear wheel of the EX

350 and move the rear wheel

backwards to remove the slack from

the chain (fig. 10).

3. Once this is achieved the wheel nuts

must then be relocked into position

and wheel alignment must be

checked (while turning the wheel,

visually check that the clearance

between the wheel and the frame

parts have clearance).

1 2 ... 10 11 12 13 14 15 16 17

Sem comentários

BLADEZ PB-SM806 Guia de Resolução de Problemas Página 15